Home > News

Installation diagram and procedure of explosion-proof armoured cable sealing joint

Jul. 29, 2019

Installation diagram and procedure of explosion-proof armoured cable sealing joint shared by Explosion-Proof Cable Gland supplier.

The product is divided into five parts: basic body small clip ring big clip ring rubber core breaking head. The following is the product schematic diagram, which is the product installation method.

Product structure diagram.

Installation diagram of Explosion Proof Cable Gland sealing joint.

Explosion Proof Cable Gland

Armored layer armored joint with iron sheet inner core.

First, put the clamping ring of the clamping ring of the clamping head on the armored cable.

Then cut off the outer rubber skin of the part to be fixed with scissors (it is better to use scissors because there are no professional tools, it is better to have professional tools), (note: When cutting external rubber must cut together or in the product line will distorted) after cut off the skin, be careful of the iron sheet armoured layer out slowly, every piece of armor used scissors to cut in the middle, after been cut two armoured plate into four, then put the small card ring wear on through cable, the cut of armoured layer coated on a snap ring (if armoured layer is too long can cut off the appropriate a fraction) and then a set good calories ring set in advance in the small card ring, installed after the snap ring with basic body then put rubber core set in good card ring finally broken head, The joint and the armored cable are connected. Finally, it is enough to know the thread part of the joint and the equipment.