Home > News

LED Explosion-proof Lamp Use And Maintenance

Nov. 20, 2018

1. Before installing the LED Explosion Proof Stainless Steel Light, check whether the basic technical data listed on the nameplate meets the actual conditions of use.

2. There is a cable lead-in wire with a diameter of φ10mm~φ14mm. It is connected to the terminal through a rubber seal ring, and the cable is pressed tightly with a compression nut to seal it and prevent it from being pulled out.

3. Check whether the wiring is correct before use and whether the fastening screws (bolts) on the outer casing are tightened. The cable ground wire should be grounded reliably.

4. “Do not open the cover with electricity” during maintenance and do not bump or damage the rubber sealing gasket.

5. During maintenance, if the sealing ring and sealing gasket of the introduction device are found to be aging, they should be replaced in time to ensure the protection performance.

6. LED Explosion Proof Light should be protected from impact or strong vibration during transportation, and should be protected against rain and snow.

7. LED lights should be stored in the air circulation, no dripping water and liquid intrusion, the ambient temperature is not higher than +40 ° C, not lower than -25 ° C, the relative humidity of the air is not more than 98% (+25 ° C) in the warehouse.

8. In the surrounding environment where the LED explosion-proof lamp is stored, it should not contain corrosive gases that damage the metal and its insulation.

LED Explosion Proof Stainless Steel Light