Home > News

Waterproof Processing For Low Pressure Cable Glands

Apr. 11, 2018

Waterproof cable glands include waterproof metal cable gland and waterproof brass cable gland. We would like to share the waterproof processing steps for low pressure cable glands.

1) After the terminals are crimped, wrap the waterproof filler around the terminals. Shrink the heat shrink tube.

2) If it is a generally damp environment, wrap a waterproof packing tape at each end of the cable and shrink the jacket tube (the ends of the jacket tube must be glued).

3) If the environment is harsh, waterproof self-adhesive tape must be used to enhance the waterproof (also can use shrink tape, we generally use self-adhesive tape, shrink tape is used for cable damage repair). 

Waterproof Metal Cable Gland

The way is:

A. After filling the waterproof filling glue, wrap a layer of self-adhesive waterproof tape around the filling glue or stretch the self-adhesive waterproof tape to wind multiple layers, but the thickness should not be too thick so as not to cause the insulation sleeve to go in too much.

B. Shrink the heat shrink tube over the plastic.

C. Wrap the waterproof tape on both ends of the heat-shrinkable tube, and then wind a layer of self-adhesive waterproof tape. Wrap the waterproof tape and the self-adhesive tape on both ends of the cable insulation sheath, and then heat and shrink the sheath tube.

SANHUI can provide high quality waterproof metal cable gland and waterproof brass cable gland.